Panasonic DMR-HW100EBK Operating Instructions - Page 91

Photo, TV Guide, Broadcast

Get Panasonic DMR-HW100EBK PDF manuals and user guides View all Panasonic DMR-HW100EBK manuals
Add to My Manuals
Save this manual to your list of manuals

Page 91 highlights

Photo TV Guide The contents of the SD card cannot be read. ¾ Remove the card from the slot and then insert again. If this does not solve the problem, turn off and turn on the unit again. Copying, deleting and setting protection takes a long time. ¾ When there are a lot of folders and files, it may sometimes take a few hours. Photos do not playback normally. ¾ The images that were edited on the PC, such as PROGRESSIVE JPEG, etc., may not play back. (> 97) USB This unit does not recognize the USB connection correctly. ¾ If USB device is connected to this unit while using a video communication the connection will not be recognized. Press [EXIT] and reconnect USB device. ¾ If inserted during playback the USB device may not be recognized by this unit. Disconnect and reconnect the USB device. If it still does not recognize the connection, turn this unit off and on again. ¾ USB devices connected using a USB extension cable other than the supplied with the Wireless LAN Adaptor DY-WL10 (optional) or a USB hub may not be recognized by this unit. The TV Guide System does not receive any data. ¾ If signal quality is bad (ghost images or limited reception), the TV Guide system may not be able to receive any data. The empty field is displayed for some or all channels. ¾ Some channels are not supported by the TV Guide system. The TV Guide information is not displayed properly. ¾ Set the clock correctly. (> 79) ¾ There was a programme change, or TV Guide information from a broadcast station was possibly not correctly transmitted. Check the current programme, e.g. on the Web site for the TV Guide system provider or station provider. Broadcast After the Auto Setup, there are channels that cannot be seen. ¾ The Auto Setup was started and interrupted. Do Auto Setup again. (> 71) Picture regularly breaks up on some channels. ¾ Adjust the aerial reception with "Manual Tuning". (> 71) Picture very infrequently breaks up on some or all channels. ¾ Electrical atmospheric interference caused by local or distant lightening storms or heavy rain with wind in "leafy" locations may cause pictures to break up and audio to mute or distort momentarily. Troubleshooting 91 VQT3F57

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
Troubleshooting
VQT3F57
91
The contents of the SD card cannot be read.
¾
Remove the card from the slot and then insert
again. If this does not solve the problem, turn off
and turn on the unit again.
Copying, deleting and setting protection
takes a long time.
¾
When there are a lot of folders and files, it may
sometimes take a few hours.
Photos do not playback normally.
¾
The images that were edited on the PC, such as
PROGRESSIVE JPEG, etc., may not play back.
(
>
97)
This unit does not recognize the USB
connection correctly.
¾
If USB device is connected to this unit while using
a video communication the connection will not be
recognized. Press [EXIT] and reconnect USB
device.
¾
If inserted during playback the USB device may
not be recognized by this unit.
Disconnect and reconnect the USB device. If it still
does not recognize the connection, turn this unit off
and on again.
¾
USB devices connected using a USB extension
cable other than the supplied with the Wireless
LAN Adaptor DY-WL10 (optional) or a USB hub
may not be recognized by this unit.
The TV Guide System does not receive any
data.
¾
If signal quality is bad (ghost images or limited
reception), the TV Guide system may not be able
to receive any data.
The empty field is displayed for some or all
channels.
¾
Some channels are not supported by the TV Guide
system.
The TV Guide information is not displayed
properly.
¾
Set the clock correctly. (
>
79)
¾
There was a programme change, or TV Guide
information from a broadcast station was possibly
not correctly transmitted.
Check the current programme, e.g. on the Web
site for the TV Guide system provider or station
provider.
After the Auto Setup, there are channels that
cannot be seen.
¾
The Auto Setup was started and interrupted.
Do Auto Setup again. (
>
71)
Picture regularly breaks up on some
channels.
¾
Adjust the aerial reception with “Manual Tuning”.
(
>
71)
Picture very infrequently breaks up on some
or all channels.
¾
Electrical atmospheric interference caused by local
or distant lightening storms or heavy rain with wind
in “leafy” locations may cause pictures to break up
and audio to mute or distort momentarily.
Photo
USB
TV Guide
Broadcast