Philips DVDR615 User manual - Page 68

English Troubleshooting (cont'd) Problem The index screen flickers when a DVD+R is inserted. Picture is fuzzy and brightness varies when copying DVD Video discs or prerecorded video cassettes. The message 'NO SIGNAL' appears. The message 'Recording of will start within 1 minute' appears. The message 'Insert recordable disc' appears. The message 'Maximum number of timers reached' appears. The message 'Collision' appears. Solution - You can finalize the disc using the following function: 1) Press OPEN/CLOSE on the DVD recorder to open the disc tray. 2) Insert the disc but do not close the tray. 3) Hold down button number {4} on the remote control until the tray closes. 'FINALIZING' appears on the display panel. 4) If finalizing has been successful, the Picture Index screen will appear. - This happens if you try to copy DVDs or video cassettes that have been copy-protected. Even though the picture on the TV is fine, but the recording on a DVD+R(W) is faulty. This interference is unavoidable with copy-protected DVDs or video cassettes. - The DVD+R(W) has recording lifetime, please change a new disc for recording. - Check that the cable is plugged in firmly. - If a recording is made from a video recorder, change the tracking on the video recorder. - The DVD recorder may not be able to recognize the video input signal if this signal is poor or does not comply with relevant standards. - Select { Switch now } to switch the DVD recorder to standby mode.A programmed timer recording will only start recording if the DVD recorder is in standby mode. - Select { Suspend } will suspend the timer recording. - Select { Cancel recording } will cancel the timer recording. - Either no disc was inserted or a disc was inserted that cannot be used for recordings. Insert a disc that can be recorded upon. Locate on the disc the right position for the recording. Press STOP button. Turn off the DVD recorder by pressing STANDBY-ON button. - It has reached the maximum programmed, no more recordings are allowed. Press TIMER button, select the programmed recording (TIMER block) you want to check or clear using 3 4 button. - The timer recording overlaps with another timer recording. - If you ignore this warning, the programmed recording with the early start time will start first. The second recording will then lack the beginning. - Change the information for one of the two recordings. - Delete one of the two recordings. 68 DVDR610_615_37_Engfinal434 68 8/16/04, 4:12 PM 3139 246 14221