Pioneer AVH-4000NEX Owners Manual - Page 72
Fastening this product to the fac, tory radio-mounting bracket., Fit the microphone lead into the,
View all Pioneer AVH-4000NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Chapter 31 Places that may be exposed to rain, such as close to the door or on the vehicle's floor. Install this product horizontally on a surface within 0 to 30 degrees tolerance (within 5 degrees to the left or right). Improper installation of the unit with the surface tilted more than these toler- ances increases the potential for errors in the vehicle's location display, and might otherwise cause reduced display performance. 30° × 9 mm), depending on the shape of the bracket's screw holes. If the pawl interferes with installation, you may bend it down out of the way. 1 1 Screw (2 mm × 4 mm) Installing the microphone Install the microphone in a place where its direction and distance from the driver make it easiest to pick up the driver's voice. Be sure to turn off (ACC OFF) the product before connecting the microphone. ˙ Mounting on the sun visor 1 Fit the microphone lead into the groove. 1 2 Attach the microphone clip to the sun visor. 1 2 When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. 3 2 1 Microphone lead 2 Groove Leave ample space 5 cm 5 cm ˙ Installation using the screw holes on the side of this product Fastening this product to the factory radio-mounting bracket. Position this product so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side. Use either the truss head screws (5 mm 72 × 8 mm) or flush surface screws (5 mm En 2 1 Factory radio-mounting bracket 2 Dashboard or console 3 Truss head screw or flush surface screw Be sure to use the screws supplied with this product. ˙ Fastening the front panel If you do not plan to detach the front panel, the front panel can be fastened with supplied screw. 1 1 Microphone clip 2 Clamps Use separately sold clamps to secure the lead where necessary inside the vehicle. Install the microphone on the sun visor when it is in the up position. It cannot recognize the driver's voice if the sun visor is in the down position.