Ricoh Aficio SP 3510SF Quick Guide - Page 439

9. Troubleshooting Problem Solution There is considerable delay between the print start command and actual printing. • Processing time depends on data volume. High volume data, such as graphics-heavy documents, take longer to process. • If "Processing..." is displayed on the screen, the machine is receiving data. Wait for a while. • To speed up printing, reduce the printing resolution using the printer driver. For details, see the printer driver Help. Prints fall in front of the machine when they are output. Raise the stop fence. See p.46 "Unpacking". Prints do not stack properly. • Paper is damp. Use paper that has been stored properly. See p.84 "Paper and Other Media". • Raise the stop fence. See p.46 "Unpacking" The whole printout is blurred. • Paper is damp. Use paper that has been stored properly. See p.84 "Paper and Other Media". • If you enable [Toner Saving] under [System Settings], printing is generally less dense. • Toner is almost depleted. If "Replacement Required: Print Cartridge" appears on the screen, replace the print cartridge. • Condensation may have collected. If rapid change in temperature or humidity occurs, use this machine only after it has acclimatized. The toner is powdery and comes away from the paper, or the printed image has a matt appearance. Check if the levers for printing on envelopes inside the rear cover are properly set. Pull up the levers. Printed envelopes come out creased. Check if the levers for printing on envelopes inside the rear cover are properly set. Lower the levers. Changing the Printer Driver Settings You may eliminate certain problems by changing the printer driver settings as described below. 386