Samsung SRP-275CEPG Operation Manual - Page 14
Switch settings
View all Samsung SRP-275CEPG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
CHAPTER 3 Switch settings Although the factory settings are best for almost all users, if you have special requirements, you can change the DIP Switch. 3.1 Setting the DIP Switches Your printer has two sets of DIP Switches. The functions of the switches are shown in the following table. 3.1.1 DIP Switch setting for Epson (ESC/POS) mode DIP Switch 1 Switch 1-1 1-2 1-3 Function Emulation selection(*1) Auto cutter 1-4 BUSY condition 1-5 Serial interface selection 1-6 Print NV bit image #1 after cutting 1-7 Near end switch 1-8 Print column ON OFF Refer to the following table Enable Receive buffer full Memory switch Enable Enable 42/35 Disable Receive buffer full or Offline DIP Switch Disable Disable 40/33 Default OFF OFF OFF OFF OFF OFF OFF DIP Switch 2 (RS232C serial interface model) Switch Function ON OFF 2-1 Data receive error Ignore Print "?" 2-2 Reserved 2-3 Hand shaking XON/XOFF DTR/DSR 2-4 Word length 7 bits 8 bits 2-5 Parity check Enable Disable 2-6 Parity selection EVEN ODD 2-7 Baud rate selection(*2) 2-8 Refer to the following table Default OFF OFF OFF OFF OFF OFF OFF DIP Switch 2 (Parallel interface model) Switch Function 2-1 Auto line feed 2-2 2-3 2-4 2-5 2-6 2-7 2-8 ON Enable Undefined OFF Disable Default OFF OFF 3-2 (*1) Emulation Selection (DSW 1-1and 1-2) Emulation 1-1 1-2 EPSON OFF OFF STAR OFF ON CITIZEN ON OFF EPSON-KP ON ON EPSON-KP(EPSON Kitchen printer Mode) : A alarm is generated by printer after auto cutting and in paper end error. (*2) Baud rate selection (Transmission speed) Transmission 2-7 2-8 2400 baud ON ON 4800 baud OFF ON 9600 baud OFF OFF 19200 baud ON OFF 3.1.2 DIP Switch setting for Citizen(iDP 3550) mode DIP Switch 1 Switch 1-1 1-2 1-3 Function Emulation selection(*1) Auto cutter 1-4 CBM command 1-5 1-6 International characters(*2) 1-7 1-8 CR mode ON OFF Refer to the following table Enable CBM2 mode (iDP3530 system) Disable CBM1 mode (iDP3540 system) Refer to the following table CR CR+LF Default OFF OFF OFF OFF ON OFF 3-3