Samsung SRP-275CEPG Operation Manual - Page 38

CHAPTER 5 CONTROL COMMANDS LIST 5.4.2 Commands description for Epson mode (TM-U220) HT [Name] Horizontal tab [Format] ASCII HT Hex 09 Decimal 9 [Range] None [Default] None [Description] Moves the printing position to the next horizontal tab. [Notes] This command is ignored unless the next horizontal tab position has been set. Horizontal tab positions are set by ESC D. If the next horizontal tab position exceeds the printing area, the printer sets the printing position to [Printing area width + 1]. When underline mode is turned on, the underline will not be printed under the tab space skipped by this command. LF [Name] Print and line feed [Format] ASCII LF Hex 0A Decimal 10 [Range] None [Default] None [Description] Prints the data in the print buffer and feeds one line. [Notes] The amount of paper fed per line is based on the value set using the line spacing command (ESC 2 or ESC 3). After printing, the printing position moves to the beginning of the line. 5-6 CR [Name] [Format] [Range] [Default] [Description] Print and carriage return ASCII CR Hex 0D Decimal 13 None None When auto line feed is enabled (DSW 2-1) (Only available with Parallel Interface) Executes printing and one line feed as LF When auto line feed is disabled Prints data in print buffer and does not feed the paper [Notes] With a serial interface, the command performs as if auto line feed is disabled. With a parallel interface, enabling or disabling the auto line feed can be selected by the DIP Switch (DSW2-1). After printing, the printing position moves to the beginning of the line. 5-7