Samsung SRP-275CEPG Operation Manual - Page 75
Double width characters remain valid until the double width character cancel
View all Samsung SRP-275CEPG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
CHAPTER 5 CONTROL COMMANDS LIST SO [Name] [Format] [Description] (CBM2 Mode) Specifying the double width character/shift-out side characters ASCII SO Hex 0E The data following this command is printed doubled in the horizontal direction. Double width characters remain valid until the double width character cancel command is entered, but they are also cancelled after they are printed one line. Note that the double width characters take up two ordinary characters worth of width. In the case of a serial interface, if 7-bit data is selected, the shift-out side character is printed. SI [Name] [Format] [Description] (CBM1 Mode) Canceling the double width character ASCII SI Hex 0F This command cancels the double width characters set with SO. The data following this command are printed in the ordinary character width. SI [Name] [Format] [Description] (CBM2 Mode) Canceling the double width character/Specifying the shift-in side characters ASCII SI Hex 0F This command cancels the double width characters set with SO. The data following this command are printed in the ordinary character width. In the case of a serial interface, if 7-bit data is selected, the shift-in side character is printed. 5-126 LF [Name] Printing and paper feed [Format] ASCII LF Hex 0A [Description] If the print buffer contains the data, this command will feed the line after printing. If not, the command only feeds the line. CR [Name] Printing [Format] ASCII CR Hex 0D [Description] This command prints the data. If the DIP switch segment 1-8 is set to OFF, the printer will print the data in the print buffer and feed the paper by one line. If it is set to ON, the printer will print the data in the print buffer and will not feed the paper. DC1 (CBM1 Mode) [Name] Initializing the printer [Format] ASCII DC1 Hex 11 [Description] This command initializes the printer. The input buffer is not cleared. The settings of the DIP switch segments are not re-read. 5-127