Samsung SRP-275CEPG Operation Manual - Page 99

CHAPTER 5 CONTROL COMMANDS LIST ESC d n [Name] Paper cut instruction [Format] ASCII ESC d n Hex 1B 4C n Decimal 27 64 n [Range] 0 ≤n ≤3 48 ≤ n ≤ 51 ("0" ≤ n ≤ "3") [Default] ------ [Description] This command executes the auto-cut according to the n specification, after printing data in the line buffer. After auto-cutter is executed, the printer considers that position to be the top of the page. Auto cutter n 0, 48 1, 49 2, 50 3, 51 Auto cutter Partial cut at the current position. This command is ignored on tear-bar models. Partial cut at the current position. This command is ignored on tear-bar models. Paper is fed to cutting position, then a Partial cut is executed. On tear-bar models, paper is fed to the tear-bar position. Paper is fed to cutting position, then a partial cut is executed. On tear-bar models, paper is fed to the tear-bar position. ESC BEL n1 n2 [Name] Set external drive device 1 pulse width [Format] ASCII ESC BEL n1 n2 Hex 1B 07 n1 n2 Decimal 27 7 n1 n2 [Range] 1 ≤ n1 ≤ 127 1 ≤ n2 ≤ 127 [Default] n1 = 20 (Energizing time: 200 msec) n2 = 20 (Delay time: 200 msec) [Description] Sets the energizing and delay times for drive of the external device (such as cash drawers). Energizing time = 10 x n1 (ms) After printing, this is executed by BEL (External device 1 drive instruction) or FS (External device 1 drive instruction (real time)). This command is ignored when n1 and n2 are out of range. - n1 = 0 or n2 = 0: This command is ignored. - When n1 > 128: n1 = 128. When n2 > 128, n2 = 128. 5-106 5-107