Samsung SRP-275CEPG Operation Manual - Page 50

CHAPTER 5 CONTROL COMMANDS LIST ESC m [Name] Partial cut (one point left uncut) [Format] ASCII ESC i Hex 1B 69 Decimal 27 105 [Range] None [Default] None [Description] Executes a partial cut of the paper roll with one point left uncut. ESC g [Name] Start macro record [Format] ASCII ESC g 0 [ ]k [d1...dm]k Hex 1B 67 00 [ ]k [d1...dm]k Decimal 27 103 0 [ ]k [d1...dm]k [Range] [Description] [Notes] k ≤ 10 0 ≤ nL ≤ 255 0 ≤ nH ≤ 255 [(256 x nH) + nL ]1 + ...+ [(256 x nH) + nL ]k < 2Mbit (256KB) 0 ≤ d ≤ 255 Start macro definition (Define logo) - k = the number of total macro index - (256 x nH) + nL = the Length of each macro - m = (256 x nH) + nL The SRP-275 Printer maintains a 2M bit (256KB) section of flash memory to save NV bit image. This command is useful to define NV bit image (Logo). The NV bit image is printed by ESC g n. 5-30 ESC g n [Name] Execute Macro [Format] ASCII ESC g n Hex 1B 67 n Decimal 27 103 n [Range] 1 ≤ n ≤ 10 [Description] Execute macro using the parameter by n. [Notes] n = Macro index number. The NV bit image is defined by ESC g. This command should be used only when the macro is downloaded by ESC g command. ESC p [Name] Generate pulse [Format] ASCII ESC p m t1 t2 Hex 1B 70 m t1 t2 Decimal 27 112 m t1 t2 [Range] m = 0, 1, 48, 49 1 ≤ t1 ≤ 255 1 ≤ t2 ≤ 255 [Default] None [Description] Outputs the pulse specified by t1 and t2 to the specified connector pin m as follows: m Connector Pin 0 Drawer kick-out connector pin 2 1 Drawer kick-out connector pin 5 [Notes] - The pulse for ON time is (t1 x 2 msec) and for OFF time is (t2 x 2 msec). If t2 < t1, the OFF time is equal to the ON time. If t2 < 50, t2 is supposed to be 50. 5-31