Samsung SRP-275CEPG Operation Manual - Page 90

CHAPTER 5 CONTROL COMMANDS LIST ESC z 0 [Name] Set line feed to 1/12 inch [Format] ASCII ESC z 0 or ESC z "0" Hex 1B 7A 00 1B 7A 30 Decimal 27 122 0 27 122 48 [Range] ------ [Default] 1/6 inch [Description] Sets subsequent line feeds to 1/12 inch. ESC z 1 [Name] Set line feed to 1/6 inch [Format] ASCII ESC z 1 or ESC z "1" Hex 1B 7A 01 1B 7A 31 Decimal 27 122 1 27 122 49 [Range] ------ [Default] 1/6 inch [Description] Sets subsequent line feeds to 1/6 inch. ESC A n [Name] Define n/72 inch pitch line feed [Format] ASCII ESC A n Hex 1B 41 n Decimal 27 65 n [Range] 0 ≤ n ≤ 85 [Default] n = 12 (1/6 inch line feed) [Description] Defines line feed amount for one line as n/72 inch. To enable this code, ESC 2 (line feed pitch setting) is required. 5-88 ESC 2 [Name] Set ESC A line feed pitch [Format] ASCII ESC 2 Hex 1B 32 Decimal 27 50 [Range] ------ [Default] ------ [Description] Sets one line feed amount to the value defined by ESC A (n/72 inch pitch line feed definition). Line feed pitch is set to 1/6 inch if executing this command when ESC A (n/72 inch pitch line feed definition) is not set. ESC 3 n [Name] Set line feed to n/216 inch line feed pitch [Format] ASCII ESC 3 n Hex 1B 33 n Decimal 27 51 n [Range] 0 ≤ n ≤ 255 [Default] n = 36 (1/6 inch) [Description] Sets subsequent line feed amounts to a value approximate to n/216 inch. Because the minimum pitch for the paper feed mechanism is 1/144 of an inch, the setting value will be approximated according to the following equation. INT (n x 2/3 + 0.5)/144 of an inch ESC y n [Name] Set line feed to n/144 inch line feed pitch [Format] ASCII ESC y n Hex 1B 79 n Decimal 27 121 n [Range] 0 ≤ n ≤ 255 [Default] n = 24 (1/6 inch) [Description] Sets subsequent line feed amounts to a n/144 inch. 5-89