Samsung SRP-275CEPG Operation Manual - Page 95

CHAPTER 5 CONTROL COMMANDS LIST HT [Name] Move horizontal tab [Format] ASCII HT Hex 09 Decimal 9 [Range] ------ [Default] ------ [Description] Move print position to next horizontal tab position. The current moves to the next tab position when at the horizontal tab position. This command is ignored with under the following conditions. - When there is no horizontal tab set : - When the current position is the same as the furthest right horizontal tab position or to the right of it. In the underline/upperline modes, underlines and upperlines are not printed in the spaces created by a horizontal tab. ESC D n1 n2 nk NUL [Name] Set horizontal tab [Format] ASCII ESC D n1 n2 nk NUL Hex 1B 44 n1 n2 nk 00 Decimal 27 68 n1 n2 nk 0 [Range] 1 ≤ n ≤ Maximum printable digits ≤ 255 0 ≤ k ≤ 16 [Default] (Not set) [Description] Uses the left edge as a standard to set the horizontal tab to the position of current ANK character pitch x n). The horizontal tab reference point is the left edge of the paper, regardless of the left margin. When upside-down printing is specified, the right side becomes the reference. ANK character pitches, including right spaces, are unaffected by expansion settings. All other horizontal tabs set before setting the horizontal tab using this command are cancelled. A maximum of 16 horizontal tabs can be set, but the tab position must satisfy the following conditions. If the following conditions are not met, data up to the NUL code is discarded. Normal tabs that meet the conditions below are set and tabs after errors occur are not set. - 1 ≤ n1 ≤ n 2 ≤ nk - nk ≤ Printable region The horizontal tab set using this command is unaffected by changing the character pitch. All horizontal tabs are cleared by inputting ESC D NUL. 5-98 5-99