Samsung SRP-275CEPG Operation Manual - Page 88

CHAPTER 5 CONTROL COMMANDS LIST SI [Name] Select upside-down printing [Format] ASCII SI Hex 0F Decimal 15 [Range] ------ [Default] Upside-down printing cancelled [Description] Specifies upside-down printing This command is enabled only when at the top of the line. Therefore, upside down and right-side up characters cannot both exist in the same line. This command is enabled for following. - ANK characters - Chinese characters - Bit-Image DC2 [Name] Cancel upside-down printing [Format] ASCII DC2 Hex 12 Decimal 18 [Range] ------ [Default] Upside-down printing cancelled [Description] Cancels upside-down printing This command is enabled only when at the top of the line. 5-84 ESC RS i n [Name] Specify/cancel character rotate mode [Format] ASCI ESC RS i n Hex 1B 1E 69 n Decimal 27 30 105 n [Range] 0≤n≤2 48 ≤ n ≤ 50 ("0" ≤ n ≤ "2") [Default] Character rotation cancelled (n = 0) [Description] Specifies direction to rotate print (clockwise) or to cancel rotation for subsequent data, according to the n value. n Set rotation 0, 48 Cancelled (0° rotation) 1, 49 270° rotation 2, 50 90° rotation Rotated characters cannot be applied with underlines or upperlines. The relationship between double-high and double-wide is reverse to when cancelled when rotating. Cautions when character fonts - Characters are printed using 7 x 9 fonts. - Registered characters are printed using 7 x 9 font for download characters as well. - Double height of character is not available when in character rotate mode. - This command is recommended not to use because print quality is not guaranteed. 5-85