Sony DCR-TRV50 Operating Instructions (primary manual) - Page 43

Playback - Basics Playing back a tape Date/time 50min 0:00:23:01 JUL 4 2002 12:05:56 AM Various settings 40min 0:00:23:01 [a] [b] [c] AUTO 60 AWB F1.8 9dB [d] [e] [f] [g] [a] Tape counter [b] SteadyShot OFF [c] Exposure mode [d] White balance [e] Gain [f] Shutter speed [g] Aperture value To not display various settings Set DATA CODE to DATE in the menu settings (p. 208). The display changes as follows when you press DATA CODE on the Remote Commander: date/time y no indicator Various settings Various settings are your camcorder's information when you have recorded. In the recording, the various settings will not be displayed. When you use the data code, bars (-- -- --) appear if: - A blank portion of the tape is being played back. - The tape is unreadable due to tape damage or noise. - The tape was recorded by a camcorder without the date and time set. Data code When you connect your camcorder to the TV, the data code appears on the TV screen. Remaining battery time indicator during playback The indicator indicates the approximate continuous playback time. The indicator may not be correct, depending on the conditions in which you are playing back. When you close the LCD panel and open it again, it takes about one minute for the correct remaining battery time to be displayed. 43