Sony SRR4 Product Manual (SRMASTER: SRR4 Operation Manual) - Page 52

Error Messages and Warning Messages About Error Messages When the system stops operating incorrectly because of an internal error, a warning tone sounds and a popup window appears in the display of the control panel with an error message. Tip Only one message is displayed at one time, even if multiple errors occur. The number of current errors appears at the bottom of the popup window. Be sure to check the messages for all errors. Example: Popup window displaying error message "0010: FAN1 STOP" (fan stopped) dB SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI 0 -10 -20 ERROR -30 -60 EE EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP LR LR LR LR LR LR LR LR LR LR LR LR LR LR LR LR 1 2 3 4 050 160 7 8 9 10 11 12 13 14 15 16 PLAYFALN OSCTKOP VTR OOOOO TCR LTC INTRP DF EXT-LK KEYINHI FAN 1 Stopped RECINHI 00 00 00 00 H1 Error(s)M/ 2 WarninSg(s) F IN 16.5V REMAIN 10min ENCODE STANDARD F65RAW 23.98P LOCAL EE 21:46 Indicates that there is one current error message. Indicates that there are two current warnings (see page 52). To view the other messages, rotate the SELECT/ENTER dial on the control panel. When an error message appears Eliminate the cause of the error, and power the system off and on again. If the same error message appears again when the system is powered on, contact a Sony service representative. To close the error message popup window Press the HOME button or the BACK button. The error code is shown in the operation status and warnings section of the HOME screen (see page 13) until the cause of the error is removed. About Warning Messages If an error is detected, a warning message code appears in the operation status and warnings section of the HOME screen (see page 13). To check the content of warning messages Press the SELECT/ENTER dial on the control panel. A popup window appears to display messages for the current warnings. Tip Only one message is displayed at one time, even if multiple warnings occur. The number of current errors and warnings appears at the bottom of the popup window. Be sure to check the messages for all errors and warnings. Example: Popup window displaying warning message "0007: REC INHIBIT MODE" (recording inhibit mode) dB SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI SDI 0 -10 -20 WARNING -30 -60 EE EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP EMP LR LR LR LR LR LR LR LR LR LR LR LR LR LR LR LR 1 2 3 4 050 067 7 8 9 10 11 12 13 14 15 16 PLAYRELC OICNKHIBIT MODE VTR OOOOO TCR LTC INTRP DF EXT-LK KEYINHI Rec Inhibit Mode RECINHI 00 00 00 00 HO Error(s)M/ 3 WarninSg(s) F IN 16.5V REMAIN ENCODE F65RAW 10min STANDARD 23.98P LOCAL EE 21:46 Indicates that there are no current error messages (see page 52). Indicates that there are three current warnings. To view the other messages, rotate the SELECT/ENTER dial on the control panel. When a warning message appears Take any action that may be needed to eliminate the cause of the warning. Appendix 52 Error Messages and Warning Messages