TASCAM DA-6400 TELNET protocol specifications - Page 8

TASCAM DA-6400/DA-6400dp TELNET protocol specifications Command details The commands, data and Machine ID given here are ASCII characters. Commands are 2-byte characters, the Machine ID is a 1-byte character and Data are each 1-byte characters. The specifications for take and project numbers that this unit can handle are as follows. If a number is specified for an item that does not exist, however, the command will be treated as invalid. Take number 999 maximum Project number 99 maximum INFORMATION REQUEST This requests information about the controlled device, including the version of the software used. Command 0F Machine ID 0 Data none Return INFORMATION RETURN [8F] STOP This stops the controlled device. Command 10 Machine ID 0 Data none Return none PLAY This starts controlled device playback. Use RECORD (Record) to start recording from recording standby. Command 12 Machine ID 0 Data none Return none RECORD This puts the controlled device into recording or recording standby status. Command 13 Machine ID 0 Data 2 bytes Data 1 Data 2 Meaning Notes 0 0 Record This starts recording from recording standby. 0 1 Record Pause This starts recording standby 0 2 Take Split This starts a new take during recording. ・ If the unit receives any Data other than the above, it will send ILLEGAL [F2]. Return none PAUSE This pauses playback of the controlled device. Use RECORD (Record Pause) to pause recording. Command 14 Machine ID 0 Data 2 bytes Data 1 Data 2 Meaning Notes 0 1 Pause On This pauses playback. ・ If the unit receives any Data other than the above, it will send ILLEGAL [F2]. Return none 8 TEAC Corporation