Xerox 4540 Service Manual - Page 132

rack. As a last resort, a minimum of four people could remove the server. If only two people are available, remove power supplies, disk drives, and system controller to reduce the weight to about 50 pounds before removing the server. See below. ▼ To Remove the Server From the Rack 1. If you need to lighten the server, you can remove following from the rack: a. Power supply units: To remove power supplies, see "To Remove a Power Supply (CRU)" on page 3-43. b. Cable management assembly: To remove the cable management assembly if necessary. See one of the following docs depending on your CMA version: i. Sun Fire X4500/X4540 Installation Guide ii. Sun X4500-J Slide Rail Installation Guide (X4500) iii. "Early-Production Slide Rail and CMA Information" on page G-1 (X4500) c. System Controller: To remove the system controller, see "Replacing the System Controller (FRU)" on page 3-68. 2. From the front of the rack, squeeze the slide-rail locks (with green plastic handles) to release the lock and pull the server about 1.5 inches from the rack. 3. Push the green plastic tabs on the middle slide rails to release the first stop. 4. Push the green plastic tabs on the middle slide rails to release the second stop and pull the server out about 36 inches (about 90 cm) from the rack. 5. If you need to lighten the server, open the disk drive access cover and remove the disk drives. See "To Remove the Drives Access Cover" on page 3-13. 6. Slide the server completely out of the slide rails and place on a clean, stable surface. 3-12 Sun Fire X4500/X4540 Server Service Manual • May 2010