Xerox 4540 Service Manual - Page 186

Note - This component is a FRU and must be replaced only by qualified service technicians. Contact your Sun Service representative for assistance. Installing a PCI-X card is similar to installing the GRASP board. For a list of supported PCI cards, see the following web site: http://www.sun.com/servers/x64/x4540/optioncards.jsp For an updated list of components, see the following web site: http://sunsolve.sun.com/handbook_pub/Systems/ From this web site, click on the Sun Fire X4540 server, then on Full Components List for the list of components. The full description of the component is listed with a Buy button beside each one. Note - Option cards supported by operating systems are listed on the platform-specific product webpage under Companion Products. To check if the driver of your option card is available for download, check the Option Cards link on the Product Page. 1. Power off the server. See Section 3.7.1, "Powering Off the Server" on page 3-10. 2. Remove the cable management assembly if necessary. See one of the following docs depending on your CMA version: ■ Sun Fire X4500/X4540 Installation Guide ■ Sun X4500-J Slide Rail Installation Guide (X4500) ■ "Early-Production Slide Rail and CMA Information" on page G-1 (X4500) 3. Remove the system controller. See "To Remove the System Controller (CRU)" on page 3-70. 4. Install the PCI-X board. Align the PCI-X board connectors with the metal tab on the left and the bottom connectors on the I/O board. Then push the board into place. See FIGURE 3-28. 5. Replace the system controller. See "Replacing the System Controller (FRU)" on page 3-68. 6. Replace the cable management assembly if necessary. See one of the following docs depending on your CMA version: ■ Sun Fire X4500/X4540 Installation Guide 3-66 Sun Fire X4500/X4540 Server Service Manual • May 2010