Xerox 4540 Service Manual - Page 255

Figure Legend 4 Cable Management Arm (CMA) 5 Left pinhead 6 Right pinhead 3. Push the CMA toward the chassis. The CMA drops below. 4. Remove the CMA from the rear of the chassis. 5. Remove the CMA from the slide rail extension by loosening the captive screw and pulling it outwards. G.2 Removing the Cable Management Arm for the X4500 1. Mount the CMA to the CMA-to-chassis bracket. a. Align the two pinheads on the CMA with the keyholes in the bracket. b. Support the CMA by placing your hand under it. Push the CMA upward into the bracket until the pinheads on the CMA are secured into the keyholes of the bracket. c. Pull the CMA toward you until the CMA left and right pinheads lock into the keyholes with an audible snap. 2. Insert the other end of the CMA into the slide rail extension and hand-tighten the knurled fastener found on the CMA. 3. Install cables to your server, as required, and route the cables through the CMA cable hangers. Appendix G Early-Production Slide Rail and CMA Information G-3