Xerox 4540 Service Manual - Page 149
Remove fan tray 0 and fan tray 1., Using a No. 1 Phillips screwdriver
![]() |
View all Xerox 4540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
1. Power off the server. See "Powering Off the Server" on page 2-3. 2. If the server is in a rack, slide it far enough out of the rack so that you can access the fan modules. 3. From the front of the enclosure, open the fan cover. Using a No. 2 Phillips screwdriver, loosen the two captive screws on the left and right sides. 4. Remove fan tray 0 and fan tray 1. 5. Remove the disk drive access cover so that the fan cover opens more freely. See "To Remove the Drives Access Cover" on page 3-13. Using a No. 2 Phillips screwdriver, loosen the two captive screws on the left and right sides. 6. Using a No. 1 Phillips screwdriver, remove the three screws (see 1 in FIGURE 3-13) on the front indicator board, then remove (see 2 in FIGURE 3-13). FIGURE 3-13 Removing the Front Indicator Board Screws Chapter 3 Maintaining the Sun Fire X4500 and X4540 Servers 3-29
![](/manual_guide/products/xerox-4540-service-manual-31966a4/149.png)