Xerox 4540 Service Manual - Page 161
To Access the Third Power Supply Bay, From the back of the enclosure, remove the power supply cover.
![]() |
View all Xerox 4540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
▼ To Access the Third Power Supply Bay Note - If you are installing the third power supply, you must first remove the power supply cover and cable management arm mounting plate (power supply filler panel). 1. From the back of the enclosure, remove the power supply cover. Note - If another system is installed in the rack above your system and blocks access to the power supply cover. To complete some of the following steps, you may need to go to the front of your system and pull it out so it extends all the way out of the rack. 2. Using a No. 1 Phillips screwdriver, remove the two screws on the power supply cover. Pull the cover toward the rear of the chassis and lift. Some extra effort may be required to disengage the eight mushroom-head pins that secure the power supply cover to the chassis. See FIGURE 3-18. FIGURE 3-18 Removing the Power Supply Area Cover Screws Chapter 3 Maintaining the Sun Fire X4500 and X4540 Servers 3-41
![](/manual_guide/products/xerox-4540-service-manual-31966a4/161.png)