ZyXEL ARMOR Z1 User Guide - Page 12
LEDs, 4G WLAN/WPS, Power, Internet
View all ZyXEL ARMOR Z1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 1 Introduction 1 Make sure the power LED is on (not blinking). 2 Press the WPS button for more than three seconds and release it. Press the WPS button on another WPS-enabled device within range of the ARMOR Z1. Note: You must activate WPS in the ARMOR Z1 and in another wireless device within two minutes of each other. For more information on using WPS, see Section 8.2 on page 49. 1.7 LEDs Figure 1 Front Panel Internet 5G WLAN/WPS 2.4G WLAN/WPS Power The following table describes the front panel LEDs. Table 1 Front Panel LEDs LED COLOR Power/System White Off STATUS On Blinking DESCRIPTION The ARMOR Z1 is receiving power and functioning properly. The ARMOR Z1 is in the process of starting up, default restoring, or My ZyXEL Cloud Server online registration pairing. The ARMOR Z1 is not receiving power. ARMOR Z1 User's Guide 12