ZyXEL P-324 User Guide - Page 83

Prestige 324 User's Guide Table 6-7 WAN: IP LABEL DESCRIPTION Allow between WAN and LAN Select this check box to forward NetBIOS packets from the LAN to the WAN and from the WAN to the LAN. If your firewall is enabled with the default policy set to block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall rule that forwards NetBIOS traffic. Clear this check box to block all NetBIOS packets going from the LAN to the WAN and from the WAN to the LAN. Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls. Apply Click Apply to save your changes back to the Prestige. Reset Click Reset to begin configuring this screen afresh. 6.7 Configuring WAN MAC To change your Prestige's WAN MAC settings, click WAN, then the WAN MAC tab. The screen appears as shown. Figure 6-6 MAC Setup The MAC address screen allows users to configure the WAN port's MAC address by either using the factory default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the factory assigned default MAC Address. Otherwise, click Spoof this computer's MAC address - IP Address and enter the IP address of the computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting or upload a different ROM file. It is recommended that you clone the MAC address prior to hooking up the WAN Port. WAN Screens 6-13