ZyXEL P-324 User Guide - Page 94

Prestige 324 User's Guide Table 6-10 Advanced Setup LABEL DESCRIPTION Drop Type the AT Command string to drop a call. "~" represents a one second wait, for example, "~~~+++~~ath" can be used if your modem has a slow response time. Answer Type the AT Command string to answer a call. Drop DTR When Select this check box to have the Prestige drop the DTR (Data Hang Up Terminal Ready) signal after the "AT Command String: Drop" is sent out. AT Response Strings CLID Type the keyword that precedes the CLID (Calling Line Identification) in the AT response string. This lets the Prestige capture the CLID in the AT response string that comes from the WAN device. CLID is required for CLID authentication. Called ID Type the keyword preceding the dialed number. Speed Type the keyword preceding the connection speed. Call Control Dial Timeout Type a number of seconds for the Prestige to try to set up an outgoing (sec) call before timing out (stopping). Retry Count Type a number of times for the Prestige to retry a busy or no-answer phone number before blacklisting the number. Retry Interval Type a number of seconds for the Prestige to wait before trying (sec) another call after a call has failed. This applies before a phone number is blacklisted. Drop Timeout Type the number of seconds for the Prestige to wait before dropping (sec) the DTR signal if it does not receive a positive disconnect confirmation. Call Back Delay Type a number of seconds for the Prestige to wait between dropping (sec) a callback request call and dialing the corresponding callback call. Apply Click Apply to save your changes back to the Prestige. Cancel Click Cancel to exit this screen without saving. EXAMPLE ~~+++~~ath ata NMBR CONNECT 60 0 10 20 15 6-24 WAN Screens