HP 450c HP DesignJet 430/450C/488CA Printer - UserÂ’s Guide - Page 41
Getting help - designjet printer
View all HP 450c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
SETUP 1 Setting up your printer Task 9: Set up the printer in your application software When choosing from a device list, follow these preferences, which are listed here in priority sequence. Preference 1: HP DesignJet 430/450C/455CA/488CA Preference 2: HP DesignJet 330/350C Preference 3: HP DesignJet 700/750C/750C Plus/755CM Preference 4: HP DesignJet 650C with a preference for C2858B/C2859B rather than C2858A/C2859A. Preference 5: HP DesignJet 220 Preference 6: HP DesignJet 200 Preference 7: HP DesignJet 600 HP DesignJet Preference 8: HP-GL/2 Device or a similar option including a reference to HP-GL/2. Preference 9: Any of: HP 7595B DraftMaster SX HP 7596B DraftMaster RX HP 7599A DraftMaster MX HP 7595C DraftMaster SX Plus HP 7596C DraftMaster RX Plus HP 7599B DraftMaster MX Plus If any of the options quoted above appears, then your software supports HP-GL/2. If it doesn't support HP-GL/2, then go to Preference 10. Preference 10: HP 7586B This printer supports HP-GL. However, if you choose this device you may not be able to use your printer's parallel connection-depending on the application software. Getting help If in doubt, or if you have problems with your driver, refer to the section at the end of Chapter 9 for advice on how to get help. See page iv for information about Hewlett-Packard's web site for DesignJet printers. 1-25