HP DL760 ProLiant DL760 Generation 2 Server Maintenance and Service Guide - Page 82
I/O Expansion Slot Cover, Removing the I/O expansion slot cover
UPC - 613326397428
View all HP DL760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
I/O Module Removal and Replacement Procedures IMPORTANT: If any of the I/O expansion slots require inspection, remove the 11-slot hot-plug basket. Refer to "11-slot Hot-Plug Basket" in this chapter for removal instructions. The I/O expansion slots are distributed among one primary PCI bus and five separate PCI-X peer buses. NOTE: Each PCI-X bus will automatically configure to run in the most advanced mode (PCI-X or PCI) and the highest frequency supported by all expansion boards installed in the slots on the bus. NOTE: The ProLiant DL760 G2 server ships with a Network Interface Controller (NIC) preinstalled in slot 11. I/O Expansion Slot Cover To remove the I/O expansion slot cover: 1. Press down on the top of the expansion slot release lever (1) and push the lever up (2). 2. Remove the expansion slot cover (3). Figure 6-6: Removing the I/O expansion slot cover Reverse steps 1 and 2 to replace the I/O expansion slot cover. HP ProLiant DL760 Generation 2 Server Maintenance and Service Guide 6-7 HP CONFIDENTIAL Codename: Jed Part Number: 201262-003 Last Saved On: 2/10/04 4:10 PM