HP DL760 ProLiant DL760 Generation 2 Server Maintenance and Service Guide - Page 95
Fan Cage Assembly, Remove the I/O module. Refer to Removing the I/O Module in
UPC - 613326397428
View all HP DL760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
I/O Module Removal and Replacement Procedures 3. Lower the new hot-plug fan into the I/O module until it rests on the I/O board connector. Push the fan into the connector. The fan locking latch will lock into place. 4. Be sure that the LED is green and close the I/O lid. Fan Cage Assembly The fan cage assembly has an integrated center support bracket. To remove the fan cage assembly: 1. Power down the server. Refer to "Pow ering Down the Server" in Chapter 2. 2. Remove the I/O module. Refer to "Removing the I/O Module" in t his chapter. 3. Remove the hot-plug fans. Refer to "Hot -Plug Fans" in this chapter. 4. Unscrew the "captive" s crew (1) and lift the screw up. 5. Push in the tab on the side of the I/O module (2). 6. Remove the fan cage assembly by rotating it up and out (3), lifting the hook (4) on the rear of the assembly off the top spool on the rear of the module and clearing the flange (5) and notch (6) of the module. Figure 6-20: Removing the fan cage assembly 6-20 HP ProLiant DL760 Generation 2 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: Jed Part Number: 201262-003 Last Saved On: 2/10/04 4:10 PM