HP DL760 ProLiant DL760 Generation 2 Server Maintenance and Service Guide - Page 92
is complete. For more information about PCI Hot Plug LEDs, refer to PCI Hot Plug, Close the I/O lid.
UPC - 613326397428
View all HP DL760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
I/O Module Removal and Replacement Procedures 4. Press on the top of the appropriate expansion slot release lever (1) and open the lever toward the rear of the expansion slot (2). 5. Unseat the expansion board by pulling up on the plastic tab (3) and lift the board out of the server (4). Figure 6-16: Removing an I/O expansion board 6. If you are only removing the board, install an expansion slot cover. Close the slot release lever. Be sure that the lever latches into the closed position. 7. If you are replacing the board, install the new I/O expansion board. 8. Close the slot release lever. Be sure that the lever latches into the closed position. 9. Reconnect any I/O cables to the new board. 10. Return power to the slot through the PCI Hot Plug button or software application. The green LED will flash during the power-up transition and will turn on when the power-up is complete. For more information about PCI Hot Plug LEDs, refer to "PCI Hot Plug LED Indicators" earli er in this chapter. 11. Close the I/O lid. HP ProLiant DL760 Generation 2 Server Maintenance and Service Guide HP CONFIDENTIAL Codename: Jed Part Number: 201262-003 Last Saved On: 2/10/04 4:10 PM 6-17