HP Designjet T790 HP Designjet T790 and T1300 ePrinter: User's Guide - English - Page 40
Change the units of measurement, Con network settings, Personal settings
View all HP Designjet T790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Change the units of measurement To change the units of measurement in the front-panel display, press , then , then Setup > Front panel options > Select units, and select English or Metric. By default the units are set to metric. Configure network settings You can view and configure the network settings from the Embedded Web Server, the HP Utility or the front panel. To do so with the Embedded Web Server, select the Setup tab, then Networking. With the HP Utility under Windows, select the Settings tab, then Network Settings. Under Mac OS, select Configuration > Network Settings. The following settings are available. ● IP Configuration method: Specify the way to set an IP address, selecting BOOTP, DHCP, Auto IP or Manual. ● Host name: Specify the IP name of the printer. The name may contain up to 32 ASCII characters. ● IP address: Specify the IP address of the printer. Duplicate IP addresses on a TCP/IP network will cause communication to fail. TIP: Make sure that the combination of IP address, subnet mask and default gateway is valid. If these three fields are inconsistent, you may not be able to connect to the printer at all until you fix the problem from the front panel. TIP: If you change the current IP address and click Apply, the browser loses the current connection to the printer because it is pointing to the old address. To reconnect, browse to the new IP address. ● Subnet mask: Specify a subnet mask, which determines which bits specify the network and which bits uniquely specify the node within the network. ● Default gateway: Specify the IP address of a router or computer that is used to connect to other networks or sub-networks. If none exist, use the IP address of the computer or the IP address of the printer. ● Domain name: Specify the name of the DNS domain in which the printer resides (for example, support.hp.com). NOTE: The domain name does not include the host name: it is not the fully qualified domain name, such as printer1.support.hp.com. ● Idle timeout: Specify the time that an idle connection is allowed to remain open when a remote computer is waiting for the printer. The default value is 280 seconds. If set to zero, the timeout is disabled and the connection is allowed to remain open indefinitely. ● Default IP: Specify the IP address to use when the printer is unable to obtain an IP address from the network when powered on or when reconfigured to use BOOTP or DHCP. ● Send DHCP requests: Specify whether DHCP requests are transmitted when a legacy default IP address or a default Auto IP is assigned. Personal settings 32 Chapter 4 Personalizing the printer ENWW