HP LaserJet 5p/mp Service Manual - Page 54
Removing the Formatter Board and Shield
View all HP LaserJet 5p/mp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
HP LaserJet 5P Printer Service Supplement Removal and Replacement Removing the Formatter Board and Shield 1. Remove any installed SIMMs. Note There are two TORX screws holding the I/O connector in position (Callout 1 in Figure 21). These are the only two TORX screws in the HP LaserJet 5P printer. Note also the location of the test print button hole (Callout 2) on the side of the formatter board cover. Figure 21 TORX Screw Locations. 47
Removing the Formatter Board and Shield
1.
Remove any installed SIMMs.
Note
There are two TORX screws holding the I/O
connector in position (Callout
1
in Figure 21).
These are the only two TORX screws in the HP
LaserJet 5P printer.
Note also the location of
the test print button hole (Callout
2
) on the side
of the formatter board cover.
Figure 21
TORX Screw Locations.
HP LaserJet 5P Printer Service Supplement
Removal and Replacement
47