HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 216

6.4.17 JPOS Drivers for the Receipt Printer Drivers - CheckScanner Note: The check scanner feature is only available on the HP Hybrid printer that has imaging capabilities. The following is image of the model of the HP Hybrid printer with imaging capabilities: The JPOS drivers are included in the HP factory image (C:\xxxxx\Point of Sale\Receipt Printer\JPOS POS Printer) and are also available from HP.COM. The following is an overview of the steps to test the receipt printer followed by detailed steps: 1. Open Printer/Cash Drawer/MICR Unit Test Application. • C:\xxxxx\Point of Sale\Receipt Printer\JPOS POS Printer\HPJPOSPrinter.bat. 2. Click on the CheckScanner tab. 3. Click the Open button. 4. Click the Claim button. 5. Click the Enable button. 6. Insert a piece of paper face up that you wish to capture an image of during this test in the front of the printer until the LED comes on. The paper should be inserted face up in the slip portion of the printer. 7. Click the Begin button in the left TransactionPrint box. 8. Click the End button in the left TransactionPoint box. The printer will make some noise and move the paper through the imager. 9. Check the Data Events Enabled checkbox. 10. Click the Retrievelmage button. After the button is pressed the status will be updated and some information will be filled about the image. 11. Click the DisplayImage button to view the image that was scanned. 12. To Exit the application one needs to "Disable/Release/Close" the printer and then click on the "X" to close the application. 13. The piece of paper that was inserted in step 7 can be removed from the imager portion of the printer by pulling on the paper; there will be slight force needed when the paper is pulled. Page 216 of 545