HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 341

USB HID Keyboard (default): Scanner Firmware version 3.06.068 or newer: Keyboards\HID Keyboard Device • Hardware Id: HID\VID_03F0&PID_5739 POS Barcode Scanner\POS HID Barcode scanner • Hardware Id: HID\VID_03F0&PID_5739 Universal Serial Bus controllers\USB Composite Device • Hardware Id: USB\VID_03F0&PID_5739 Scanner Firmware version older than 3.06.068: Keyboards\HID Keyboard Device • Hardware Id: HID\VID_03F0&PID_2A39 6.10.3 Drivers The drivers needed for each scanner operating mode are listed in the table below. All drivers are included in the HP factory image and are also available from HP.COM. Operating mode HID-POS USB COM USB HID Keyboard (default) Windows driver None (native) Required None (native) OPOS or JPOS driver Optional Required Not applicable The OPOS and JPOS drivers are configured for USB COM mode by default. When switching the scanner operating mode between USB COM and HID-POS, the OPOS and JPOS drivers must be reconfigured to match: Reconfiguring for OPOS is accomplished either by running the HP Scanner OPOS Setting utility (included and installed as part of the OPOS driver) in C:\\HP\HP Mobile Scanner OPOS\Scanner OPOS Configuration Utility or by uninstalling and reinstalling the OPOS driver itself. When opening the HP Scanner OPOS Setting utility and selecting the Device Type (ex: HPMobileScanner), the current scanner operating mode will be shown/selected under Communication Type. Reconfiguring for JPOS is accomplished by editing jpos.xml in C:\xxxxx\Point of Sale\Scanner (Mobile Retail Jacket)\Mobile Retail Jacket Scanner JPOS\JposScanner. The Port value should be set to "COM" for USB COM mode or "HID" for HID-POS mode. Page 341 of 545