HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 334

6.9.6 Imaging Testing In order for the scanner to capture an image, the scanner must be programmed into the USBCOM mode (OPOS). In order to put the scanner into this mode, scan the USB-COM barcode from the appropriate scanner folder (i.e. Imaging Scanner / Linear Scanner / Wireless BT scanner, etc.). The following is overview of the steps to test the imaging barcode scanner followed by detailed steps: 1. Install HP Imaging Scanner Configuration on the system. This may be found on HP.COM. 2. After installation is complete open the HP Imaging Scanner Configuration. 3. Detect the scanner attached to the unit by selecting "Device Autodetection" option 4. Select on "Search On Connection" option. 5. Select the COM port that the scanner is attached to. If the scanner is not in USB-COM mode scan the barcode on the previous page or scan the barcode that appears on the screen and then select your COM port that the scanner is assigned to when in USB-COM mode: 6. Click on the scanner picture until the menu appears (will see a message that it is retrieving data from the scanner). 7. Click on the eyeglass icon (view image) in the menu bar to put the scanner into capture mode. When this option is selected the scanner will beep. 8. Select "Capture on Trigger" option located at the bottom of the screen. 9. Point the scanner to the item that one wishes to scan and pull the trigger to capture the image. 10. Exit the application. Detailed Steps 1. Install HP Imaging Scanner Configuration on the system. This may be found on HP.COM. 2. After installation is complete open HP Imaging Scanner Configuration. 3. Detect the scanner attached to the unit by selecting "Device Autodetection" option Page 334 of 545