HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 495

of 545

7.5.3

Touch Screen calibration

For Microsoft POSReady 2009 and Windows XP Professional operating system there is no

calibration needed due to the projective capacitive technology therefore there is no calibration utility

for the HP RP7 15/17 inch projective capacitive touch.

For Windows 7 (32 and 64 bit) and POSReady 7 (32 and 64 bit) operating system the following are

the steps to open the calibration utility

BUT

it is not necessary for the HP RP7 15/17 inch projective

capacitive touch:

1.

Click on the START button.

2.

Click on CONTROL PANEL.

3.

In the search box type in “Tablet PC Setting” (without the quote) and in the list of results select

“Table PC Settings”.

4.

On the DISPLAY tab under DISPLAY OPTION select CALIBRATE.

Note:

When one calibrates for the screen for the first time, the screen uses 16 different

reference points. If one selects the calibration option again only 4 points are used.

To

perform a 16-point calibration again, in the Tablet PC Properties window, tap the Reset

button.

5.

Follow the instructions on the screen and click YES to save your calibration settings.

7.5.4

Touch in Dual Monitor Configuration in POSReady 2009 or XP

This section and the touch drivers are for Microsoft POSReady 2009 and Microsoft Windows XP

operating system.

In a dual touch PCAP monitor configuration, in order to have touch on both monitors one must have

driver’s version 7.5.52.00 or later which can be obtained on the

HP.COM

website.

After the drivers

are obtained the following is the process to install the drivers in dual touch PCAP configuration.

1.

Go to the folder where the PCAP touch drivers have been downloaded and extracted.

2. Open th

e SETUP.EXE utility with “/dual” parameter (i.e. SETUP.EXE /dual) and follow the

prompts on the screen.

3.

After the drivers are installed and the unit is rebooted, need to identify the touch monitors to

the touch drivers.

In the system tray double click on the

“Multi

-mouse-

daemon”

icon to open

the configuration of the touch monitors.

This utility was installed in the system tray because

of the “/dual” parameter

.

4.

Follow the prompts that appear when

“Multi

-mouse-

daemon” utility

is opened.

The following

are the screens that will appear.

Initial screen that appears when the utility is opened:

HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 495

Touch Screen calibration, Touch in Dual Monitor Configuration in POSReady 2009 or XP

Page 495 highlights