HP Retail Integrated 2x Point of Sale POS Peripherals Configuration Guide - Page 98

6.4.8.3 Windows Printer Driver (Ethernet) for v1.0.5 for POSReady 2009 The following is an overview of the steps to test the receipt printer followed by detailed steps: 1. Print out the diagnostic form on the printer in order to obtain the IP Address and the RAW TCPIP Port information. 2. Go to Control Panel - Devices and Printers and select "Add a printer". 3. Select "Add a local printer". Do not select the network option. 4. Select "Create a new port" option. 5. Select "Standard TCP / IP Port" option and click on the next button. 6. Enter the IP Address that is printed on the diagnostics form and click on the "Next" button. 7. On the "Additional port information required" GUI select "Standard Generic Network Card" and click on "Next" and click the "Finish" button. 8. When the "Install the printer driver" GUI appears select "Have Disk" option. 9. When the "Install From Disk" option appears browse to the location where the drivers are located and select the "OEMPRINT.INF" file and click "Open" 10. When you are back to the "Install the printer Driver" GUI "HP Receipt" printer will appear, click on the "Next" button. 11. On the "Print Sharing" GUI select the option "Do not share this printer" and click on the "Next" button. 12. On the "Print Test Page" GUI select the "No" option and click on the "Next" button. The configuration is not complete is the reason for selecting no. 13. Click on the "Finish" button. 14. Go to the "Devices and Printers" and right click on the printer that was just installed and select "Properties". 15. Select the "Ports" tab. 16. Highlight the port for the printer that was installed and select "Configure Port". 17. Go to the "Raw Settings" section on the "Configure Standard TCP/IP Port monitor" GUI. In the "Port Number" section enter 9001 (double check the diagnostics form to confirm 9001 is on the "Raw TCPIP Port" and click OK. 18. Close the printer properties GUI screen. 19. Go to the "Devices and Printers" and right click on the printer that was just installed and select "Properties". 20. Click on "Print Test Page" and printout should occur. Detailed Steps 1. Print out the diagnostic form on the printer in order to obtain the IP Address and the RAW TCPIP Port information. Steps to obtain a diagnostics printout A. Plug the printer into the network and have power to the printer. B. Run a diagnostic printout and obtain the printer IP address from the printout. C. Be sure paper is in the printer (1). D. Open the receipt cover (2). E. Press and hold the paper feed button (3). F. Close the receipt cover (2). Page 98 of 545