Invacare 3GAR Owners Manual 2 - Page 51

SECTION 5-WHEELCHAIR OPERATION ƽ ACTUATOR CONTROL WARNING Use only the actuator controls listed in the following chart to activate the tilt/ recline/elevate functions. DO NOT USE any other actuator controls. Such devices may result in excess heating and cause damage to the actuator and associated wiring and could cause a fire, death, physical injury or property damage. If such devices are used, Invacare shall not be liable and the limited warranty is void. SEATING SYSTEM ACTUATOR CONTROL TRSS TRCM TAC SAC ESC 2G TARSYS - TILT ONLY Y Y Y N N 2G TARSYS - TILT ONLY WITH POWER N Y N N N LEGS 2G TARSYS - RECLINE ONLY N Y Y N N 2G TARSYS - RECLINE ONLY WITH POWER LEGS N Y N N N 2G TARSYS - TILT/RECLINE N Y N N N POWER TILT ONLY Y Y Y N N ELEVATING SEAT ONLY N N Y N Y POWER TILT/ELEVATING SEAT N N Y N N NOTE: This procedure applies to wheelchairs with 2G Tarsys, Elevating Seat and/or Power Tilt seating systems ONLY. Single Function Toggle Switch NOTE: For this procedure, refer to FIGURE 5.2 on page 52. 1. Make sure the wheelchair is on a level surface. 2. Refer to the chart for the operation of the seating system using a single function toggle switch mounted on the right side of the wheelchair. 3. Release single function toggle switch to neutral position. SEATING SYSTEM SINGLE FUNCTION TOGGLE SWITCH FORWARD BACK 2G TARSYS - TILT ONLY Decrease Tilt Angle Increase Tilt Angle ELEVATING SEAT ONLY** Raise the Seat Lower the Seat POWER TILT ONLY Decrease Tilt Angle Increase Tilt Angle **NOTE: The seat MUST be tilted/reclined so the back angle is less than 20° relative to the vertical position before elevating/lowering the seat. Part No 1134791 51 3G Storm Series® Wheelchairs