Invacare 3GAR Owners Manual 2 - Page 68

SECTION 6-FRONT RIGGINGS Installing/Adjusting Adjustable Angle Flip-Up Footplates Installing Adjustable Angle Flip-up Footplates NOTE: For this procedure, refer to FIGURE 6.9. 1. Slide the half clamp over the footplate hinge. 2. Loosely tighten the two flat screws that secure the footplate to the half clamp. 3. Adjust the footplates to the necessary angle and depth for the user. Refer to Installing/ Adjusting Adjustable Angle Flip-Up Footplates on page 68. Adjusting Adjustable Angle Flip-up Footplates Depth NOTE: For this procedure, refer to FIGURE 6.9. 1. Remove the two flat screws, washers and locknuts that secure articulating footplate to the half clamp. NOTE: Observe the angle of the articulating footplate for reinstallation. 2. Move articulating footplate to one of four mounting positions. 90° Footrest Support Flat Screws Articulating Footplate Footplate Hinge Nylon Adjustment Screw NOTE: If desired depth is still not obtained, rotate the half clamp on the footplate hinge 180o. 3. Retighten the two flat screws, washers and locknuts. NOTE: The settings for positioning the articulating footplates on the half-clamps may vary for each footplate. Washers Half Clamp Locknuts Footplate Hinge FIGURE 6.9 Adjusting Adjustable Angle Flip-up Footplates - Depth 4. Refer to Angle on page 69 or Perpendicular and/or Inversion/Eversion Adjustment on page 69. 3G Storm Series® Wheelchairs 68 Part No 1134791