Invacare 3GAR Owners Manual 2 - Page 73
Installing the Power Elevating Legrests, Removing the Power Elevating Legrests, Adjusting the Power
View all Invacare 3GAR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
SECTION 6-FRONT RIGGINGS Installing the Power Elevating Legrests NOTE: For this procedure, refer to FIGURE 6.15. 1. Turn power legrest to side (open footplate is perpendicular to wheelchair). Refer to Detail "A" of FIGURE 6.15. 2. Insert the mounting pin of power legrest into the mounting hole of the seat frame (Detail "A" of FIGURE 6.15). NOTE: Make sure the legrest sits flush on the seat frame. 3. Rotate the power legs toward the INSIDE of the wheelchair until it locks in place. NOTE: The footplate will be on the INSIDE of the wheelchair when locked in place. 4. Repeat STEPS 1-3 for the opposite legrest. 5. Connect power legrest connector to jumper cable (Detail "B" of FIGURE 6.15). Removing the Power Elevating Legrests NOTE: For this procedure, refer to FIGURE 6.15. 1. Disconnect power legrest connector from jumper cable. 2. Push legrest release handle and swing legrest to the outside of the wheelchair. 3. Lift up on powered legrest and remove from wheelchair. 4. Repeat STEPS 1-3 for opposite power legrest. DETAIL "A" Mounting Pin Calf Pad DETAIL "B" Mounting Hole Footplate Jumper Cable Legrest Release Handle Power Legrest Connector FIGURE 6.15 Installing/Removing/Adjusting the Power Elevating Legrests Adjusting the Power Elevating Legrests The speed of the power legrests must be adjusted to the following specifications, otherwise the legrests will not work properly. For assistance in speed adjustment, contact an Invacare Dealer or qualified technician. Part No 1134791 73 3G Storm Series® Wheelchairs