Invacare 3GAR Owners Manual 2 - Page 65

SECTION 6-FRONT RIGGINGS 60° MFX, 70° Taper NOTE: For this procedure, refer to FIGURE 6.4. 1. Remove any accessories from the footrest(s). 2. Remove the footrest from the wheelchair. Refer to Footrest Height Adjustment on page 64. NOTE: Lay the assembly on a flat surface to simplify this section. NOTE: Note the position of the spacers before disassembly. Coved Spacer 3. Remove the mounting screw and coved spacer that secures the lower footrest assembly. Mounting Screw 4. Position the footrest assembly to the desired height. Heel Loop Footrest 5. Secure lower footrest assembly with existing mounting screw and coved spacer. Securely tighten. FIGURE 6.4 Footrest Height Adjustment 60° MFX, 70° Taper NOTE: Make sure spacers are positioned properly when reassembling so as not to damage the frame mounting tubes. 6. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Footrests on page 63. 7. Reinstall any accessory onto the footrest(s). PAS4A, 93M, P904A, and PAL4A NOTE: For this procedure, refer to FIGURE 6.5. 1. Loosen, but DO NOT remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1-3 for the opposite side of the wheelchair footrest, if necessary. 93M Footrest Lug Bolt Footrest Support PAS4A, P904A, PAL4A Footrest Footrest Support Lower Footrest Locknut Lower Footrest Lug Bolt/ Locknut FIGURE 6.5 Footrest Height Adjustment - PAS4A, 93M, P904A, and PAL4A Part No 1134791 65 3G Storm Series® Wheelchairs