Netgear GSM7248v1 GSM7224 Administration manual - Page 33
Assigning Switch Name and Location Information, Saving the Configuration, The System Name
View all Netgear GSM7248v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 6.0 If an IP address is already assigned, and you do not wish to change the IP address again, simply type N. Assigning Switch Name and Location Information Ezconfig will proceed to the next step in the setup: Do you want to assign switch name and location information (Y/N/Q)? System Name: Alpha1-1 System Location: Bld1 System Contact: James There are changes detected, do you wish to save the changes permanently (Y/N)? Note: The System Name, System Location and System Contact fields accept only alphanumeric characters, characters like "#$..." are not supported. Note: The maximum length of the value cannot be longer than 31 bytes. Saving the Configuration After the name and location values are entered, Ezconfig will ask if you would like to have the changes be saved into the Flash (permanently storage). Enter Y to save the configuration. There are changes detected, do you wish to save the changes permanently (Y/N)? y The configuration changes have been saved successfully. Please enter 'show running-config' to see the final configuration. Thanks for using EzConfig! Using Ezconfig for Switch Setup 3-3 v1.0, Jan 2007