Netgear GSM7248v1 GSM7224 Administration manual - Page 37
Command Buttons, Authentication Protocol, Encryption Protocol, Submit, Refresh
View all Netgear GSM7248v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 6.0 3. Enter a new user name in the User Name field. 4. Enter a new user password in the Password field and then retype it in the Confirm Password field. Note: If SNMPv3 Authentication is to be used for this user, the password must be eight or more alphanumeric characters. 5. If you do not need authentication, go to Step 9. 6. To enable authentication, use the Authentication Protocol pulldown menu to select either MD5 or SHA for the authentication protocol. 7. If you do not need encryption, go to Step 9. 8. To enable encryption, use the Encryption Protocol pulldown menu to select DES for the encryption scheme. Then, enter in the Encryption Key field an encryption code of eight or more alphanumeric characters. 9. Click Submit. Command Buttons The following command buttons are used throughout the Web interface panels for the switch: Save Pressing the Save button implements and saves the changes you just made. Some settings may require you to reset the system in order for them to take effect. Refresh Pressing the Refresh button that appears next to the Apply button in Web interface panels refreshes the data on the panel. Submit Pressing the Submit button sends the updated configuration to the switch. Configuration changes take effect immediately, but these changes are not retained across a power cycle unless a save is performed. Using the Web Interface 4-3 v1.0, Jan 2007