Panasonic 98 Large Format 4K Professional Display Operating Instructions - Page 18
PC IN terminal connection
View all Panasonic 98 Large Format 4K Professional Display manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Pin assignments and signal names for DVI-D Input Connector PC IN terminal connection Shared with DVI-D IN. Pin No. Signal Name T.M.D.S. data 2T.M.D.S. data 2+ T.M.D.S. data 2 shield DDC clock DDC data T.M.D.S. data 1T.M.D.S. data 1+ T.M.D.S. data 1 shield +5 V DC GND (Ground) Hot plug detect T.M.D.S. data 0T.M.D.S. data 0+ T.M.D.S. data 0 shield T.M.D.S. clock shield T.M.D.S. clock+ T.M.D.S. clock- 18 English (Female) (Male) Connect a cable which matches the audio output terminal on the computer. (not supplied) Mini D-sub 15p (not supplied) Conversion adapter (if necessary) (not supplied) Stereo mini plug (M3) COMPUTER The type of computer signal that can be connected ● With regard to the typical PC input signals that are described in "Preset Signals" (see page 77), adjustment values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight PC input signal types that are not included in the list. ● Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. ● The display resolution is a maximum of 1 440 × 1 080 dots when the aspect mode is set to [4:3], and 1 920 × 1 080 dots when the aspect mode is set to [16:9]. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. ● In [ENGLISH(US)] OSD language, [16:9] is displayed as [FULL]. Note ● The PC IN terminal is DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will need to make setting changes to the computer at the time of connection. ● Some PC models cannot be connected to the set. ● There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.