Panasonic 98 Large Format 4K Professional Display Operating Instructions - Page 28
Selecting the input signal, RECALL
View all Panasonic 98 Large Format 4K Professional Display manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Selecting the input signal Select the signals input to the unit. Press or . Unit ENTER/ +/ VOL -/ MENU INPUT Note ● Displays the signal name as set in [Input label]. (see page 49) ● Outputs the sound as set in [Audio input select] in the [Options] menu. (see page 58) ● Input will not be switched unless [Input lock] is set to [Off]. (see page 59) ● Image retention (image lag) may occur on the LCD display panel when a still picture is kept on the panel for an extended period. To prevent such a problem, using the screensaver is recommended. (see page 46) RECALL It is possible to check the setting status of input label, picture mode, etc. Press . Switches input every time the buttons are pressed. ● Or, press , select the input with and press to set. INPUT HDMI1 1 HDMI2 2 HDMI3 3 HDMI4 4 DisplayPort 5 DIGITAL LINK 6 DVI-D 7 PC 8 SDI1 9 SDI2 SDI3 SDI4 1 Input in HDMI 1 terminal (Supports 4K picture)* 2 Input in HDMI 2 terminal (Supports 4K picture)* 3 Input in HDMI 3 terminal* 4 Input in HDMI 4 terminal* 5 Input in DisplayPort terminal (Supports 4K picture) 6 Input in DIGITAL LINK terminal (Supports 4K picture) 7 Input in DVI-D IN terminal 8 Input in PC IN terminal 9 Displayed when the optional "3G-SDI Terminal Board with Audio" (TY-TBN03G) is connected. *: During 4K picture input, [HDMI1] - [HDMI4] may be displayed differently depending on the settings of [Setup] - [HDMI 4K Interface]. (see page 52) Current setting status will be displayed. 16:9 Memory name: MEMORY2 Off timer 90 min 1 Input label 2 Aspect mode (see page 30) 3 Audio input (see page 58) 4 Profile name (see page 41) 5 Off timer remaining time (see page 29) 6 Clock / Mute (see page 29) ● When there is no signal to the selected input, [No Signal] is displayed for about 30 seconds at the end. ● To display the clock, set [Time], and then set [Clock display] to [On]. (see page 51, 62) ● You can set its position to be displayed with [Setup] [OSD position]. (see page 52) 28 English