Panasonic 98 Large Format 4K Professional Display Operating Instructions - Page 44
Setting RGB/PC sync signal
View all Panasonic 98 Large Format 4K Professional Display manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
[Component/RGB-in select] Select to match the signals from the source connected to the PC IN terminal. [Component] Y, PB, PR/Y, CB, CR signals [RGB] RGB signals [YUV/RGB-in select] Select to match the signals from the source connected to the DVI-D IN terminal. [YUV] [RGB] YUV signals RGB signals [Sync] This function operates only during PC input. Setting RGB/PC sync signal [Auto]: The H and V sync or synchronized signal is automatically selected. When both of them have sync, H and V sync will be selected. [on G]: Uses a synchronized signal on the Video G signal, which is input from the G connector. Setting Component sync signal [Auto]: The H and V sync or synchronized signal is automatically selected. When both of them have sync, H and V sync will be selected. [on Y]: Uses a synchronized signal on the Video Y signal, which is input from the Y connector. [XGA mode] This menu is displayed when the input signal is analogue (Component/PC). This unit supports three types of XGA signals with 60Hz vertical frequency having different aspect ratios and sampling rates (1024 × 768 @60Hz, 1280 × 768 @60Hz and 1366 × 768 @60Hz). [Auto]: Automatically selected from [1024x768]/[1280x768]/ [1366x768]. Switch the setting to suit the input signal for better display depends on the angle of view or display resolution condition. Note ● After making this setting, be sure to make each adjustment (such as [Auto setup]) on the [Position] menu as necessary. (see page 34) [Signal range] Switches the dynamic range according to the input signals below. HDMI1 to HDMI4, DIGITAL LINK, DisplayPort, SLOT (SDI1 to SDI4) [Video(16-235)]: If the input signal is the video range, Example: HDMI terminal output for DVD player [Full(0-255)]: If the input signal is full range, Example: HDMI terminal output for personal computer [Auto]: Switches the dynamic range automatically between [Video(16-235)] and [Full(0-255)] according to the input signal. ● [Auto] cannot be selected during the DIGITAL LINK and SLOT (SDI1 to SDI4) input. [Stream setting] This menu is displayed during DisplayPort input. Set the display method for stream of the device connected to the DisplayPort terminal. [Auto]: Automatically switches to the appropriate stream according to the input signal. [Single stream]: Displayed as single stream. [Input level] This menu is displayed at PC IN input. Adjustment of parts which are extremely bright and hard to see. - 32 to + 32: (Level low) - (Level high) [1080i/PsF] Sets the mode of image processing most suitable for the picture to display. [Auto]: Discriminates automatically according to the input signal. [i]: Displays the picture signal with IP conversion processing. [PsF]: Displays the picture signal with progressive conversion processing. [Noise reduction] 44 English