Panasonic WVCU360C WVCU360C User Guide - Page 14
DATA Port Connection (PS • Data), Controller end - wv cu360c can t move camera
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Example 2 shows 4 Data Multiplex Units connected with 16 combination cameras, and 4 System Controllers. 4 cameras can be connected to one Data Multiplex Unit Channel 1 Channel 2 Channel 4 Channel 13 Channel 14 Channel 16 WJ-MP204C Up to 4 Data Multiplex Units Unit address 1 Data Multiplex Unit WJ-MP204C Unit address 2 Data Multiplex Unit WJ-MP204 Unit address 4 Data Multiplex Unit WJ-MP204 Controller No. 1 360 System Controller WV-CU UP L R DOWN WV-CU360C Controller No. 2 Controller No. 4 360 System Controller WV-CU UP L R DOWN 360 System Controller WV-CU UP L R DOWN Up to 4 System Controllers See page 16 for MODE switch and CONTROLLER NO. switch settings. q DATA Port Connection (PS •Data) Data ports are connected with RS-485 cables among devices using the PS •Data protocol as follows. Notes: When using cables other than those supplied, make sure to use shielded 4-wire twisted pair cable suitable for RS-485 communication. • Internal Diagram No. Data Flow Name No. 1 1 - 2 WJ-MP204C ← WV-CU360C GND 1 Controller end TX(B) 2 1 3 WJ-MP204C ← WV-CU360C TX(A) 3 4 WJ-MP204C → WV-CU360C RX(B) 4 6 5 WJ-MP204C → WV-CU360C RX(A) 5 6 6 - GND 6 TX (B) TX (A) RX (B) RX (A) • Basic Connection Data Multiplex Unit WJ-MP204C System Controller WV-CU360C 14 DATA Termination: ON RS-485 Cable DATA Termination: ON