Panasonic WVCU360C WVCU360C User Guide - Page 56
DATA Port Connection (For WJ-SX350), DIP Switch Setting (For WJ-SX350)
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
q DATA Port Connection (For WJ-SX350) Data ports are connected with RS-485 cables among devices as follows. Note: When using cables other than those supplied, make sure to use shielded 4-wire twisted pair cable suitable for RS-485 communication. • Internal Diagram No. Data Flow Name No. 1 1 - 2 WJ-SX350 ← WV-CU360C GND 1 Controller end TX(B) 2 1 3 WJ-SX350 ← WV-CU360C TX(A) 3 4 WJ-SX350 → WV-CU360C RX(B) 4 6 5 WJ-SX350 → WV-CU360C RX(A) 5 6 6 - GND 6 • Basic Connection DATA IN 4 3 2 1 TX (B) TX (A) RX (B) RX (A) Matrix Switcher WJ-SX350 POWER LOCK ALARM MONITOR CAMERA BUSY PROHIBITED 123 456 789 0 CAMERA SITE CONTROL IRIS CLOSE OPEN UP FOCUS NEAR FAR L R ZOOM TELE WIDE DOWN POWER LOCK ALARM MONITOR CAMERA BUSY PROHIBITED 123 456 789 0 CAMERA SITE CONTROL IRIS CLOSE OPEN UP FOCUS NEAR FAR L R ZOOM TELE WIDE DOWN POWER LOCK ALARM MONITOR CAMERA BUSY PROHIBITED 123 456 789 0 CAMERA SITE CONTROL IRIS CLOSE OPEN UP FOCUS NEAR FAR L R ZOOM TELE WIDE DOWN POWER LOCK ALARM MONITOR CAMERA BUSY PROHIBITED 123 456 789 0 CAMERA SITE CONTROL IRIS CLOSE OPEN UP FOCUS NEAR FAR L R ZOOM TELE WIDE DOWN s DIP Switch Setting (For WJ-SX350) An 8-bit DIP switch mounted on the rear panel specifies the communication mode, etc. The default position is marked with an asterisk *. 78 456 23 901 CONTROLLER No. MODE DATA DC 9V IN Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8 Function System Unit Version System Unit Version System Unit Version Reserved Line termination Operation mode Baud Rate Selection Repeat Transmissions OFF * * * * Off Operator* Auto-selection* 1 time* SW position ON See the next page See the next page See the next page Not used On* Administrator Set up from CU360 3 times 58