Panasonic WVCU360C WVCU360C User Guide - Page 43
DATA Port Connection (For Multiplexer), DIP Switch Setting (For Multiplexer)
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
q DATA Port Connection (For Multiplexer) Data ports are connected with RS-485 cables among devices using the Camera Communication protocol as follows. Note: When using cables other than those supplied, make sure to use shielded 4-wire twisted pair cable suitable for RS-485 communication. • Internal Diagram No. Data Flow Name No. 1 1 - 2 WJ-FS616C ← WV-CU360C GND 1 Controller end TX(B) 2 1 3 WJ-FS616C ← WV-CU360C TX(A) 3 4 WJ-FS616C → WV-CU360C RX(B) 4 6 5 WJ-FS616C → WV-CU360C RX(A) 5 6 6 - GND 6 TX (B) TX (A) RX (B) RX (A) • Basic Connection Video Multiplexer WJ-FS616C System Controller WV-CU360C DATA OUT IN TERM. OFF ON Termination: ON RS-485 Cable DATA Termination: ON s DIP Switch Setting (For Multiplexer) An 8-bit DIP switch mounted on the rear panel specifies the communication mode, etc. The default position is marked with an asterisk *. 78 456 23 901 CONTROLLER No. MODE DATA DC 9V IN Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8 Function Unit Version Unit Version Unit Version Reserved Line termination Operation mode Reserved Data transmission SW position OFF ON See Unit Version* See Unit Version* See Unit Version* Fixed to OFF* Not used Off On* Operator* Administrator Fixed to OFF* Not used Fixed to OFF* Not used 44