Panasonic WVCU360C WVCU360C User Guide - Page 20
Unit A button Assignment, User Password, Administrator Password, User Password Certification
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
q Unit A button Assignment In this menu, a maximum of 9 system units is assigned to numeric buttons 1-9 regardless of unit address. This is to avoid double-digit unit addresses which can occur in a large system with many units connected and could confuse operators. A frequently used system unit can be easily selected in normal operation by pressing one numeric button and then the UNIT A button. 1. Display [UA-no] and press the CAM/SET button. The LED displays [A1-01] while "1" following A blinks. The first 2 digits from A1 to A9, "A numbers", stand for numeric buttons from 1 to 9 to be pressed prior to UNIT A button in normal operation. The next 2 digits are the unit address assigned in the following procedures. The default setting is shown below. A1-01 A2-02 A3-03 A1-04 A5-05 A6-06 A7-07 A8-08 A9-09 2. Select an "A number" entering a number from 1 to 9, then press the CAM/SET button. The LED displays "A number" A3 when numeric button 3 is entered for example. Available A numbers: 1-9 3. Press the CAM/SET button to validate the selection. The LED displays [A3-03] while the next two digits are blinking. 4. Enter a 2-digit unit address that you wish to assign to the "A number" (e.g., A3), then press the CAM/SET button. The LED displays [A3-99], for example, when you enter unit address 99. Available addresses: 01-99 5. Press the CAM/SET button to validate the selection. Repeat above the steps 2 to 5 as needed. 6. Press the ESC button to go back to the previous menu. q Unit B button Assignment The UNIT B button is set up in the same way as the UNIT A button for use in normal operation. Refer to the above description for Unit A button Assignment. q User Password In this menu, a 5-digit password for user authorization is registered. 1. Display [UsrP ] and press the CAM/SET button. The LED displays the registered password. 2. Enter a 5-digit password with the numeric buttons. The default setting is [12345]. Available password digits: 00000-99999 3. Press the CAM/SET button to validate the selection. 4. Press the ESC button to go back to the previous menu. q Administrator Password In this menu, a 5-digit password for administrator certification is registered. 1. Display [SUsrP] and press the CAM/SET button. The LED displays the registered password. 2. Enter a 5-digit password with the numeric buttons. The default setting is [12345]. Available password digits: 00000-99999 3. Press the CAM/SET button to validate the selection. 4. Press the ESC button to go back to the previous menu. q User Password Certification In this menu, password certification in normal operation is enabled or disabled. 1. Display [USr-C] and press the CAM/SET button. The LED displays [UC-on] or [UC-oF]. 2. Select On or Off with the joystick controller. The default setting is On. on: Password certification enabled. oF: Password certification disabled. 3. Press the CAM/SET button to confirm the selection. 4. Press the ESC button to go back to the previous menu. 20