Panasonic WVCU360C WVCU360C User Guide - Page 46
Controller Setup, Administrator Authorization, Baud Rate, Parity
UPC - 791871503454
View all Panasonic WVCU360C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
s Controller Setup Set up the baud rate and parity check mode for the controller while observing the LED on the front panel. Menu Selection LED Display Setup Menus Reading Function Setup Initial Display CAM SET Parameter Selection (default*) LED prompts you to enter password No OK Move Joystick UP and down to select blinking Administrator Password Prompt Authorization Speed Baud Rate (bps) Enter a 5-digit password, press CAM (12345*) Press twice CAM SET (1) 2 400 (2) 4 800 (3) 9 600* (4) 19 200 L R DOWN UP L R Parity Parity Check SET MON ESC (1) None* (2) Even q Administrator Authorization 1. Press the CAM/SET button while [SEtUP] is displayed. The prompt appears. 2. Enter a password with the numeric buttons, then press the CAM/SET button. The default setting is [12345]. 3. If the password entered is valid, [SPEED] appears. If password entry failed, the menu returns to [SEtUP]. q Baud Rate In this menu, the communication speed (bps: bits per second) is selected. The communication speed should match that of the WJ-FS616/FS616C. 1. Display [SPEED] and press the CAM/SET button twice. 2. Select a parameter entering a bracket-enclosed number, e.g., (3), moving the joystick to right and left, or pressing the [+] and [-] buttons. The default setting is 9 600 bps. (1) 2 400: 2 400 bps (2) 4 800: 4 800 bps (3) 9 600: 9 600 bps (4) 19 200: 19 200 bps 47 Note: Selecting a slower rate (e.g., 2 400 bps) will delay the response time (e.g., the time until an activated alarm is reset). 3. Press the CAM/SET button to validate the selection. 4. Press the ESC button to go back to the previous menu. q Parity In this menu the parity check mode is selected. 1. Display [PrtY] and press the CAM/SET button twice. 2. Select a parameter with the joystick. The default setting is None. n: None E: Even parity 3. Press the CAM/SET button to validate the selection.