Pioneer AVH-X8500BHS Owner's Manual - Page 53

Connection Installing the HDMI cable holder % Position the HDMI cable holder to insert its two lower tabs into the groove of this product, and then tighten the screw (3 mm × 5 mm) to fix the HDMI cable holder. 2 1 Optional SiriusXM Tuner connection This product 3 3 4 1 HDMI cable holder 2 Screw (3 mm × 5 mm) 3 Tab 4 Groove ! Use the HDMI cable holder when you con- nect this product with the separately sold App Connectivity Kit (CD-IH202/CD-AH200). ! Never grip the holder tightly or use force when removing or attaching. SiriusXM BUS input SiriusXM BUS cable (Supplied with SiriusXM tuner) SiriusXM tuner (sold separately) Installation Section 24 25 Notes ! Check all connections and systems before final installation. ! Do not use unauthorized parts as this may cause malfunctions. ! Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. ! Do not install this unit where: - it may interfere with operation of the vehicle. - it may cause injury to a passenger as a result of a sudden stop. ! The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet. ! Optimum performance is obtained when the unit is installed at an angle of less than 30°. Installation using the screw holes on the side of the unit % Fastening the unit to the factory radiomounting bracket. Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side. 2 1 ! When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. Leave ample space 5 cm 5 cm 5cm ! To some types of vehicles, this unit cannot be properly installed. In such case, use the optional installation kit (ADT-VA133). 3 4 1 If the pawl gets in the way, bend it down. 2 Factory radio mounting bracket 3 Use either truss (5 mm × 8 mm) or flush sur- face (5 mm × 9 mm) screws, depending on the bracket screw holes. 4 Dashboard or console En 53 English