Pioneer AVH-X8500BHS Owner's Manual - Page 60
Understanding auto EQ error, messages, Additional information - problems
View all Pioneer AVH-X8500BHS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Appendix Additional information Additional information Bluetooth Message Error-10 Cause Action The power failed Turn the ignition for the switch OFF and Bluetooth mod- then to ACC or ule of this unit. ON. If the error mes- sage is still dis- played after performing the above action, please contact your dealer or an authorized Pioneer Service Station. Pandoraâ Message Cause Action Error-19 Communication Disconnect the failed. cable from the iPod. Once the iPod's main menu is dis- played, reconnect the iPod and reset it. Start up the Pandora Application from your Device. The Pandora ap- Start up the plication has Pandora applica- not started run- tion from your ning yet. iPhone. Unable to save thumb rating. Try again later. Unable to save thumb rating. Try again later. Unable to save Bookmark. Try again later. Unable to save Try again later. Bookmark. Message Cause Action Pandora system maintenance. Try again later. Pandora system is undergoing maintenance. Try again later. Skip limit reached. Skip limit reached. Do not exceed the skip limit. This version of the Pandora Application is not supported. This version of the Pandora application is not supported. Connect an iPhone that has a compatible version of the Pandora application installed. Check Device Device error message displayed in the Pandora application. Please check your iPhone. Pandora is unable to play music. Please see your Device. Unable to play music from Pandora. Please check your iPhone. Create station within the Pandora Application on Device. No station found. Create a station in the Pandora application on your iPhone. No Active Station No station se- Select a station. lected. 60 En Message Cause Action Communication error occured. Please reconnect your device. If there is no ACK after 10 attempted retries at 750 ms, the accessory should assume that communication is interrupted and disconnect from PandoraLink. Please reconnect your iPhone and try again. Device has not been registered. Go to "Bluetooth Connection Menu" to register. No Bluetooth device found. Follow the instructions that appear on the screen. Connection Bluetooth con- failed. Press nection or con- "Connect" to nection to the retry. Pandora appli- cation failed. Follow the instructions that appear on the screen. Disconnected. Press "Connect" to reconnect the device. Bluetooth connection or connection to the Pandora application lost. Follow the instructions that appear on the screen. Understanding auto EQ error messages When correct measurement of the car's interior acoustic characteristics is not possible using auto EQ, an error message may appear on the display. In such cases, refer to the table below to see what the problem is and how it may be corrected. After checking, try again. Message Cause Action Please con- The microphone Plug the optional nect the mi- is not con- microphone se- crophone for nected. curely into the measure- jack. ment. When finished, please push HOME key. Error. Please check xxxx speaker. The microphone ! Confirm that cannot pick up the speakers are the measuring connected cor- tone of a speak- rectly. er. ! Correct the input level setting of the power amp connected to the speakers. ! Plug the micro- phone securely into the jack. Error. Please check noise. The surrounding noise level is too high. ! Stop your car in a place that is quiet, and switch off the engine, air conditioner and heater. ! Set the microphone correctly. Error. Please check battery. Power is not being supplied from the battery to this unit. ! Connect the battery correctly. ! Check the battery voltage.